Commands Listed in Alphabetical Order
TEKLink:CONN
ection? (Query Only)
This command returns the current TekLink network connection.
Group
TekLink
Syntax
TEKLink:CONNection?
Returns
INSTRUMENT when two instruments are connected through a TekLink cable.
HUB when two or more instruments are connected to a hub through a TekLink
cable.
NONE when the instrument is not connected through a TekLink cable.
Examples
TEKLINK:CONNECTION? might return :TEKLIN K:CONNECTION:INSTRUMENT,
indicating that the two instruments are connected through a TekLink cable.
TEKLink:REFClk
This command sets or queries the current state of the intrument’s TekLink
Reference Output.
Group
TekLink
Syntax
TEKLink:REFClk {ON|OFF|PENDING}
TEKLink:REFClk?
Arguments
ON specifies the on state of the instrument’s TekLink Reference Output.
OFF specifies the off s tate of the instrument’s TekLink Reference Output.
Examples
TEKLINK:REFCLK ON, sets the on state of the instrument’s TekLink Reference
Output.
TEKLINK:REFCLK? might return :TEKLINK:REFCLK OFF, indicating that the off
state of the instrume nt’s TekLink Reference Output.
2-492 DPO7000, DPO70000/B and DSA7000/B Series Programmer Manual
To Next Page
Loading...
Need help?
General
