Commands Listed in Alphabetical Order
DIAg:NUMITEM
S? (Query Only)
This query-only command returns the number of items on the currently selected
level o f test hierarchy, which ranges from 1 through 15. This command is
equivalent t
o s electing Instrument Diagnostics from the Utilities menu and then
reviewing the Diagnostic Status.
This query-
only command can be issued while diagnostics are still in progress.
Group
Diagnostics
Syntax
DIAg:NUMITEMS?
Examples
DIAG:NUMITEMS? might return :DIAG:NUMITEMS 7, indicating the number of
items on the currently selected level of test hierarchy.
DIAg:RESults? (Query Only)
This query-only command returns an abbreviated status about the results of the
last diagnostic (or test) execution. For a more explanatory status message, use
the DIAg:RESults:VERBose? query. This command is equivalent to selecting
Instrument Diagnostics from the Utilities menu a nd then reviewing the Diagnostic
Status.
This query-only command can be issued while diagnostics are still in progress.
Group
Diagnostics
Syntax
DIAg:RESults?
Related Commands
DIAg:RESults:VERBose?
Examples
DIAG:RESULTS? might return :DIAG:RESULTS "135", indicating the specific
failure code of the first test failure that occurred.
DIAG:RESULTS? might return :DIAG:RESULTS "Pass", indicating that the last
diagnostic test passed.
DIAG:RESULTS? might return :DIAG:RESULTS "***** ", indicating that the
diagnostic test was not run.
DPO7000, DPO70000/B and DSA7000/B Series Programmer Manual 2-171
To Next Page
Loading...
Need help?
General
