To Next Page

To Previous Page

Commands Listed in Alphabetical Order

Group

Waveform Trans

fer

Syntax

DATa:DESTination REF<x>

DATa:DESTination?

Related Commands

CURVe

Arguments

REF<x> is the reference where the waveform will be stored. The reference

number is speciﬁed by x, which r anges from 1 through 4.

Examples

DATA:DESTINATION? might return :DATA:DESTINATION REF3, indicating that

reference 3 is the currently selected reference memory location for waveform

data.

DATA:DESTINATION REF1 indicates that incoming waveform data be

stored in reference 1.

DATa:ENCdg

This command sets or queries the format of outgoing waveform data. This

command is equivalent to setting WFMOutpre:ENCdg, WFMOutpre:BN_Fmt,

and WFMOutpre:BYT_Or. Setting the DATa:ENGdg value causes the

corresponding WFMOutpre values to be updated and visa versa.

NOTE. Values are constrained (for outbound data) to the format of the data

speciﬁed by DATa:SOUrce.

Group

Waveform Transfer

Syntax

DATa:ENCdg

{ASCIi|FAStest|RIBinary|R PBinary|FPBinary|SRIbinary

|SRPbinary|SFPbinary}

DATa:ENCdg?

Related Commands

WFMOutpre:ENCdg, WFMOutpre:BN_Fmt, WFMOutpre:BYT_Or

2-154 DPO7000, DPO70000/B and DSA7000/B Series Programmer Manual

Tektronix MSO70000 Series Programmer's Manual

Other manuals for Tektronix MSO70000 Series