Commands Listed in Alphabetical Order
Arguments
<NR1> sets the i
ndex item about which data will be returned, which ranges from
0 through 15.
Examples
DIAG:ITEM:NAME? 2 might return :DIAG:ITEM:NAME 2,"Acquisition"
indicating that the selected menu item (2) is Acquisition.
DIAg:ITEM:RESULT? (Query Only)
This query-only command returns the result from the last execution of the item.
This command is equivalent to selecting Instrument Diagnostics from the Utilities
menu and then reviewing the Diagnostic Status.
This query-only command can be issued while diagnostics are still in progress.
Group
Diagnostics
Syntax
DIAg:ITEM:RESULT? <NR1>
Related Commands
DIAg:ITEM?, DIAg:ITEM:NAMe ?, DIAg:ITEM:FAILURES?,
DIAg:ITEM:SUBITEMS?
Arguments
<NR1> sets the index item about which data will be returned, which ranges from
0 through 15.
Examples
DIAG:ITEM:RESULT? 2 might return :DIAG:ITEM:RESULT 2,"Pass",
indicating that the item passed during the last execution.
DIAG:ITEM:RESULT? 2 might return :DIAG:ITEM:R ESULT 2,"Fail",
indicating that the item failed during the last execution.
DIAG:ITEM:RESULT? 2 might return :DIAG:ITEM:RESULT 2," ", indicating
that the item was not run.
DIAg:ITEM:SUBITEMS? (Query Only)
This query-only command returns the number of subitems associated with the
item. This command is equivalent to sele cting Instrument Diagnostics from the
Utilities menu, choosing the Subsystem, Area or Test setting and then reviewing
the resulting subitems.
This query-only command can be issued while diagnostics are still in progress.
DPO7000, DPO70000/B and DSA7000/B Series Programmer Manual 2-167
To Next Page
Loading...
Need help?
General
