DVG7 Digital Video Generator module
MOVING PICTURE
. Scrolls the active picture area of the output test signal. Select
this menu item, and then press the ENTER button to access the MOVING
PICTURE submenu. (See page 3-82.)
OVERLAY. Selects an item (logo, text, or circle) to overlay on the output test
signal and sets the blinking mode for the overlay. Select this menu item, and then
press the EN
TER button to access the OVERLAY submenu. (See page 3-83.)
AUDIO (EMBEDDED). Sets the parameters for the embedded audio on the output
test signals. Use the left (◄)orright(►) arrow button to select Group 1,
Group 2, Group 3,orGroup 4. Select any of the items, and then press the
ENTER button to access the AUDIO GROUP submenu. (See page 3-241.)
TIMING. Sets the timing offset of the serial digital video outputs relative to the
internal reference signal (frame reset signal). Select this menu item, and then
press the ENTER button to access the TIMING submenu. (See page 3-91.)
VIDEO. Enables or disables the Y, Pb, or Pr c omponent of the output s erial digital
video
signals, the EDH (Error Detection Handling) insertion, and the output
mode for an audio/video timing measurement. You can also set the resolution of
the output serial digital video signals. Select this menu item, and then press the
ENTER button to access the VIDEO submenu. (See page 3-92.)
BLACK (OPTION). This menu selection is available only with Option BK, and
sets the parameters of the serial digital black signals output from the BLACK 1
and BLACK 2 connectors. Select this menu item, and then press the ENTER
button to access the BLACK submenu. (See page 3-94.)
TG8000 Multiformat Test Signal Generator User Manual 3–81
To Next Page
Loading...
Need help?
General
