Teledyne TSIO-360-KB User Manual

FIGURE 72-30-08
TABLE OF LIMITS
(CHART 2)
REF.
No. Description
I
....
CYLINDER AND HEAD ASSEMBLY
1 Cylinder bore (lower 4 114" of barrel) diameter:
2 Cylinder bore (1" from top of barrel)
..... diameter:
..... 3 Cylinder bore (see Figure 72-20-15) taper:
4 Cylinder bore out-of-round
......... tolerance:
5 Cylinder bore (reground 0.015").
...... allowable 01s:
*6 Cylinder bore surface roughness (Nitrided Barrels)
..... using 180 grit stone, cross hatch
angle:
Microfinish (measured in
........ direction of piston travel). RMS:
"6 Cylinder bore surface roughness (Channeled Chrome)
..... using 180 grit stone, cross hatch
angle:
Finish all area within ring travel. Must show evidence
of contact with honing stone. Partially honed areas
shall not exceed 10% of bore surface and no area shall
exceed one inch in any direction.
*6 Cylinder bore surface roughness (Cermicrome)
Finish
- pitting is undesierable if present, it is
subject to the following limits:
Pits (No more than two pits in any 1
/4 inch
Dia. circle)
............... diameter:
Not more than 25 pits of any one size in entire
cylinder bore is acceptable.
7 Cylinder barrel in crankcase
........ diameter:
8 Intakevalve guide in cylinder head ..... diameter:
9 Exhaust valve guide in cylinder head .... diameter:
...
10 Exhaust valve seat (to valve guide axis) angle:
.... 11 Intake valve seat (to valve guide axis)
angle:
12 Intake valve seat insert in cylinder head
... diameter:
13 Exhaust valve seat insert in cylinder head
. . diameter:
VALVES, ROCKER ARMS AND SHAFTS
Rocker shaft in rocker arm bearing ..... diameter:
Rockerarm bearing in rockerarm.
..... diameter:
Intake valve in guide.
........... diameter:
Exhaust valve in guide
........... diameter:
....... Intake valve face (to stem axis)
angle:
.... Intake valve (max. tip regrind 0.015").
length:
lntake and exhaust valve
(full indicator reading)
.......... warpage:
Valve rocker toe to valve stem (dry lifter). ...
Rocker Arm. ............... side play:
Rotocoil to rocker arm clearance
...... clearance:
PISTONS, RINGS AND PINS
24 Piston cast 1 " from (bottom of skirt)
in cylinder:
............... diameter:
25 Top and second piston ring (semi-keystone)
in groove.
............... side clear:
Refer to Figure
72-20-1 5
Refer to Figure 72-20-1 5
0.001
I : I 0.0035
0.002 0.001
Refer to Figure 72-20-1 5
72-30-1 0 DECEMBER 1992

Teledyne TSIO-360-KB Specifications

General

Brand	Teledyne
Model	TSIO-360-KB
Category	Engine
Language	English