Valve Seat Insert
Remover and Replacer
8086
A
complete tod set to remove and install valve
seats
by
the heat-shrink method. winders are
heated to
500~-550~~. Same handle and head is
used to remove and drive down seats during
lxX=xmn-
installation. Mallet may be used on the handle
0-
as the seating force. Low water pressure on
the order of 1 to 2
p.s.i. is all that is needed
for pulling seats. This one tool
set will do all
Continental engines from
65
to 520 and 10-550.
Set includes:
*
(1) Handle/lever assembly
*
(12) Puller heads (size to fit all
Continental engines
,
*
(10) Installer pilots
*
(1)
Remover plug
*
6
feet of super flexible hose to attach to
water supply
*
Instructions
*
Storage case.
Tool is rigged for removal. Center is plugged to route water
out thru small holes
in
rim of removing head.
Fig.
1.
Installer
Valve Seat Inserts
4910 -For
1-45/64"
O.D.
Exhaust and 1
-53/64"
O.D.
Intake lnserts.
(Includes head and handle)
4956-For
1-314"
O.D.
Exhaust and 1-57/64"
O.D.
intake inserts.
(Includes head and handle)
Tool
is
rigged
for replacement. Guide on end of tool slips
into valve stem
hole for perfect alignment. No more cocked
seats.
Fig.
2
To Next Page
Loading...
Need help?
General
