Connecting Rod Reaming and
Alignment Checking Fixture
With these precision tods,
it's
easy
to check
connecting rods (without bushings) for
alignment and
warpage.
The 811 1A Base/Retainer
Kit
is required as
well as one (or more)
of
the Adapter Kits
described below. The 81
11A Kit indudes the
Q
8
Q
high-carbon
steel
base (hardened and ground for
6
long life); retaining collar, cap (for connecting
rod) and wing nut.
@
Base/Retainer
Kit
81 1 1A
The 811 IA Base/Retainer Kit
fits
the following
Adapter Kits as described below.
Adapter
Kits
These kits contain the indicator gauge assembly,
which as a dial indicator reading in ten-thou-
sandths of an inch (.000In). The gauge body is
lapped into the mating bushing for accurate
readings. Instructions are included.
Adapter Kits
8042C
for
520-470-E
Series 1.125"
807X
for
0-200,O-300,360
1
.W
&
.922"
Complete tod combining
81
11A Base with one of the
3
listed adapter kits shown
checking rod for alignment.
Reamers, Connecting Rod Bushing
High-speed steel reamers with
314"
diameter
pilot.
Use
with 8111A Base/Retainer Kt and
proper Adapter
Kit
as shown above.
87
.92OW Roughing
874-41
,923" Finishing
use together
5008
1.126" Finishing
8071
1
.OW
Flnishing
Complete tod
using same adapters
@
shown above with piston
pin reamer. See at
left
for proper reamer to use