1-20-00 TOOLS
The mechanic should be equipped with a complete set of common tools to include the minimum
of:
Wrenches
-
1
/4" thru
1
"
Common and Philister Head Screwdrivers
Pliers
-
Common Dykes, Needle Nose, Duck Bill, Vise Grip, Snap Ring.
Ratchets
1
/4", 3/8",
1
/2"
Drive
Sockets
-
1
/4"
Drive 5/32" thru
1
/2"
-
318" Drive 318" thru
1"
-
1
/2" Drive
711
6
thru
1-1
/4"
Sockets (Deepwell)
-
1
/2" Drive
7/16
thru
1
"
Feeler Gages
Leather Mallet
Torque Wrenches* (Calibrated)
-
0-500
In. Lbs.
-
0-100
Ft. Lbs.
Micrometers* (Calibrated)
*Must be currently calibrated, and the calibration must be traceable to the National Bureau of
Standards.
1-20-01
SPECIAL
TOOLS
Specific tools illustrated or similar tools marketed by other manufacturers are necessary for
service and maintenance of the aircraft engine. Tool
illustrations shown on the following
pages are used with the permission of the respective manufacturers.
Illustrations in this section show only the general appearance of tools and do not correspond
to the actual size or shape.
Details of special tools, fixtures, equipment and consumable
materials appropriate to overhaul procedures are listed in the various chapters and subsystems
of this manual; the following information is primarily for procurement purposes.
The following special tools are for
All
the Teledyne Continental Engines for the purpose of
convenience. To determine which tools are needed for your particular engine, refer to
"Special Tool Index."