31
70
-
Floating holder
No.
3
Morse male, compensates for misalignment
between reamer and work. Provides
unrestricted float.
Valve Spring
Compressor 3602
Adjustable type works on all Continental
engines.
Hook installs on rocker shaft (or on special
rocker nut furnished) and c-shaped collar
compresses spring to allow keeper removal. All
stressed parts are heated-treated steel. Handle
is approx.
18"
long for good leverage.
Push Rod Spring
Compressor 68-3
For compressing and holding push rod springs
on all engines with spring loaded tubes. The
68-3
compresses the spring, which can then be
removed with furnished clips.
Eliminates wiring springs together- to install,
simply insert spring then pull off clip! Includes
instructions.
Flaring Tool for Push
Rod Housing
4951
A
For A
&
C
Series
-
expanding ball type tool.
Balls rotate inside housing, expanding
it
into
aluminum boss.
Valve Guide Remover
4981
Removes guides by heat-shrink method.
Gylinder is heated to 47S0F, then tool injects
water to guide bore. A light tap with the side
hammer removes guide.
A
water reservoir (not
included)
supplies the low water pressure
required to cod the guides for easy removal.
Replacement guide is usually same size as the
one removed.
in use
fa
To Next Page
Loading...
Need help?
General
