Instruction manual for MH & MH+M
137
No value will be sent to the selected device unless the user presses the
key of the control panel.
All measured values entered into the measurement list are automatically
sent to the device.
When the manual data management option has been selected, it is possible to choose either
to send the last block value or, in one batch, all values stored in the measurements list. This
is only valid for storing data into the USB key or sending data through the TLC connector.
When you have activated one of the options (sending to USB, sending to TLC or sending to
printer), it is also possible to define the format in which you would like to receive the data.
There are currently three available formats:
• Block number
• Editable block name
• The description of the block (example: down probing, ...)
• Measured value
• Nominal value
• Lower tolerance
• Upper tolerance
• Deviation
• Unit
• Date
• Time
Only the measured value is sent
• Measured value
• Nominal value
• Lower tolerance
• Upper tolerance
To Next Page
Loading...
