Instruction manual for MH & MH+M
87
14 ST2 MODE
Each time when entering ST2 mode, it is necessary to calibrate the probe . Once this
has been carried out, you can either probe up or down for any measurement sequence.
Examples of a measurement sequence in ST2 mode
This mode is accessible from the main menu by activating the key at any moment.
When entering ST2 mode, the probe calibration process starts automatically (for further
details, see this chapter).
The procedure for determining the probe constant is only re-executed if
the user leaves the ST2 mode and enters in another mode (ST1 ,
Perpendicularity ). Thus, an intermediate modification of a system
parameter (in ) or the use of the integrated calculator does not imply
a re-determination of the probe constant.
14.3 Capturing the
reference value
When entering ST2 mode, once the probe calibration has been performed, the reference
values can be captured through single or double probing.
To Next Page
Loading...
