• Diameter
The main value is the diameter of the element (for further details, see
this chapter).
• Midpoint & diameter
The main value is the midpoint of the centre of the element (for further
details, see this chapter). However, two independent blocks will be
created automatically at the end of the measurement history. These
two blocks will store the midpoint value as well as the diameter of the
element.
• Diameter & midpoint
The main value is the diameter of the element (for further details, see
this chapter). However, two independent blocks will be created
automatically at the end of the measurement history. These two
blocks will store the midpoint value as well as the diameter of the
element.
To Next Page
Loading...
