TESA MICRO-HITE - 13 ST1 MODE

Instruction manual for MH & MH+M
84
13 ST1 MODE
13.1 Generality
The access to ST1 mode does not require the determination of the probe constant.
This has a direct impact on carrying out a measurement sequence. All measurements
regarding the same reference have to be carried out by probing in a direction similar to the
one chosen when the active reference has been captured.
Probing direction
(during the same measurement sequence)
Probing
(capturing the reference)
●
●
●
-
-
-
●
●
●
-
-
-
●
●
●
-
-
-
-
-
-
●
●
●
-
-
-
●
●
●
-
-
-
●
●
●
Example of a measurement sequence when the active reference has been probed down
or up.
Example of measurements when the active reference has been determined by probing down.
Example of measurements when the active reference has been determined by probing up.