Need help?Do you have a question about the TESTO 6383 and is the answer not in the manual?
General| Humidity measuring range | 0 to 100 %RH |
|---|---|
| Protection class | IP65 |
| Output signal | 4 to 20 mA |
| Power supply | 12 to 30 V DC |
| Measurement parameters | Pressure |
| Accuracy (Humidity) | ±2 %RH |
| Power supply (CO2, Humidity, Temperature) | 12 to 30 V DC |
Safety measures to prevent electrical shock during use.
Precautions for safe installation, operation, and maintenance.
Explanation of warning symbols indicating potential hazards.
Details the parameters measured by the transmitter.
Specifies the accuracy of differential pressure measurements.
Notes that accuracy depends on the probe used.
Details pressure ranges, resolution, and overload capacities.
Lists the available analog output signal types and ranges.
Lists compatible probes and their characteristics.
Explains the different types of scaling and how to set them.
Details how to configure and manage alarms for limit values.
Step-by-step guide for wiring the transmitter.
Critical safety warning before connecting the transmitter.
Detailed wiring diagram and instructions for power and analog signals.
Overview of the testo adjusting concept and methods.
Explains the 1-point adjustment process for humidity/temperature.
Detailed steps for performing 1-point adjustment with a handheld instrument.
Explains the 2-point adjustment process for humidity/temperature.
Guides on how to adjust the analog output signals.
Details the process for n-point adjustment of pressure readings.
How to parameterize relays and alarm statuses.
Overview of status, warning, and error messages shown by the transmitter.
Lists warning messages, their causes, and remedies.
Lists error messages, their causes, and remedies.
Explains how alarms are displayed, used for collective alarms, and end messages.
Explains the self-adjustment feature of the testo 6615 probe.
Instructions for installing P2A software and USB drivers.
Guides on connecting the P2A software to the transmitter.
Detailed steps to change parameters within files.
How to test transmitter functions using the software.
Overview of instrument analysis and testing actions.
How to reset the transmitter to factory settings via software.
Guides on testing the transmitter's analog outputs.
How to test the transmitter's relay outputs.
Covers various transmitter adjustment procedures using software.
Detailed steps for performing 1-point adjustment via software.
Guides on performing 2-point adjustment for humidity/temperature.
Explains the n-point adjustment process for pressure.
Guides on adjusting analog outputs using the software wizard.
To Next Page
