TESTO 6383 - Carrying out factory reset; Testing analog output

7 Parameterizing, adjusting and analyzing software (P2A software)
118
2. Perform action:
Action Explanation
Carrying out factory
reset
Reset the unit, limit value and hysteresis
parameters to factory settings (see below).
Testing analog
output
Test channel 1/optional 2/3 (see 7.3.3.3.
Testing analog output).
Test switch outputs Manually switch relays 1 to 4 to test for
proper function (see 7.3.3.4. Testing switch
output relays 1 to 4).
Display min./max.
values
Overview of the minimum and maximum
values measured since the last reset of the
transmitter (see 7.3.3.5.
Displaying min./max.
values).
3. Click on [OK] or [Cancel] to close the dialogue.
7.3.3.2. Carrying out factory reset
✓ The required instrument file is marked.
1. Click on [Test/analyze transmitter].
- The Properties of <Instrument type> <Serial number>
dialogue is opened with the Test/analyze transmitter register.
2. Mark transmitter test.
- Current operating hours are shown.
3. Confirm control query to perform the reset.
- The values are reset to the customer-specific factory settings.
4. Click on [OK] or [Cancel] to close the dialogue.
7.3.3.3. Testing analog output
✓ The required instrument file is marked.
1. Click on [Test/analyze transmitter].
- The Properties of <Instrument type> <Serial number>
dialogue is opened with the Test/analyze transmitter register.