OPTIONS
13C-16
Belt Adjustment
1. Remove the belt case cover.
2. Slightly loosen the tightener eccentric and bearing
housing capscrews (Figure 13C-14).
3. Using a deep socket, turn the eccentric tightener
by hand until the belt just becomes tight.
4. Hold the adjustment and tighten the bearing hous-
ing capscrew. Remove the socket and tighten
eccentric capscrew.
5. Torque both capscrews to 10 ft-lbs (13.5 Nm).
6. Install the belt case cover and torque to 6 to 8 ft-
lbs (8 to 10.8 Nm).
Figure 13C-14. Groomer Belt Adjustment
CAUTION
DO NOT OVERTIGHTEN BELT. Belt and bearing
may be damaged if overtightened.
To Next Page
Loading...
