Thinget XC Series - Page 219

Applied Instructions
T] 4, Pulse Segment Switch [PLSNEX
Y0PLSNEXT
M1
PLSY D0 D100 Y0
M0
z In the condition of pulse output reaches the highest frequency of current segment, and stably output,
1 turns from OFF to ON, then enter next pulse output with the speedup/speed-down time.
lse output speedu is invalid.
if M
z In pu p/speed-down process, execute this instruction
lse Stop [STOP] 5, Pu
D0PLSR
M0
M
D100 Y0
1
M8170
STOP Y0
RST M0
--------（the broken line）means the original pulse output curve
z If M000 turns from OFF to ON, PLSY activates and Y000 output pulse, D0 assign the
frequency, D001 assign the pulse number, D100 assign the speedup/speed-down time, when the
output pulse number reaches the set value, stop pulse outputting. At the rising edge of M001,
STOP instruction stop pulse outputting at Y000 immediately.
219