Tomey UD-8000 - Page 127

3-71 ■
[Iris analysis thickness]
1) The message display area (1) displays prompt messages for entering and
adjusting each point.
2) Touching the “SS” button (2) and then the SS (Sclera) point in the image
displays an SS point at that point and circles with diameters of 500-um,
750-um, and 2-mm regarding the displayed SS point as the center (Fig. 1).
3) Touch the “SS” button (2), and then touch the image or the cursor buttons
(3) to move and adjust the SS point.
4) After the SS point is defined, touch the “TMPLANE” button (4) and then the
image.
3-363
(Fig. 1)
(1) (2) (4)
(3)