■
3-74
10) When measuring ID3, touch the “ID3-IF” button (10), “ID3-IB” button (11),
and then the image. The ID3 line appears. Touch the image or the cursor
button (3) to move the point as needed. Touch the “Analyze” button (6) to
display the results after re-analysis (Fig. 4).
11) Touch “Analysis Lines” button (9) to display and hide the lines between the
points used for analysis.
12) Touch the “Point Names” button (8) to display and hide the names of all
points.
13) Touch the “All Clear” button (12) to clear all elements other than the SS and
TMPLANE points.
14) Touch the “All Clear” button (13) to clear all elements including the SS and
TMPLANE points.
3-366
(Fig. 4)
(12)
(10) (11)
(13)
To Next Page
Loading...
