3-73
■
7) When moving the SS point and/or TMPLANE point for adjustment, other iris
thickness points disappear from the image. Touch the “Analyze” button (6)
to display the results after re-analysis.
8) When the T3 line is not paralell to the iris, specify T3-I1 and T3-I2 so that
the T3 line becomes parallel to the iris. The T3 line is drawn between the
T3-I1 and T3-I2 points. When the T3 line is changed, the ID1 and ID2 lines
are automatically adjusted to be parallel to the T3 line (Fig. 3).
9) When adjusting ID1, TCPD, or ID2 point, the ID1-IF, ID1-IB, and TCPD-CB
points move to remain perpendicular to the T3 line. Touch the “Analyze”
button (6) to display the results after re-analysis.
(Fig.3)
3-365
To Next Page
Loading...
