Installing the Optional SDHC and SIM Cards
P/N 7010-1004
2-5
To install the SDHC card (Figure 2-3):
1. Ensure the receiver is turned off.
2. Remove the battery to the left of the MINTER.
3. Carefully insert the SDHC card, label side down, into the SDHC
card slot located at the top of the battery compartment.
Figure 2-3. Install SDHC Card
Once the receiver is turned on, the receiver board will detect the
SDHC card and it will be ready to use as needed.
Use only industrial-grade SDHC cards
a
. Before
using any other SDHC cards, consult with TPS
technical support about compatibility.
Do not remove the card if the receiver is powered
on. Damage to data may result from improper
removal of the card.
a. Recommended cards: Transcend® Ultra Industrial 2 GB, APRO® Industrial
4GB, SanDisk® Ultra II, or Swissbit® Industrial 2GB.
Always initialize the file system on the installed
SDHC card before the first use. Initialization
procedure is described on “Initializing the File
System” on page 5-11.
To Next Page
Loading...
Need help?
General
