Topcon GR-5 - Page 7

Table of Contents
P/N 7010-1004
iii
Chapter 4
GR-5 Receiver Setup and Survey ....................... 4-1
Receiver Setup ................................................................. 4-1
Step 1: Set up the Receivers ...................................... 4-1
Step 2: Measure Antenna Height .............................. 4-3
Step 3: Collect Data .................................................. 4-7
MINTER Operation ......................................................... 4-8
Static Surveying for Base Stations .................................. 4-11
Kinematic (Stop & Go) Surveying for Rover Stations .... 4-12
Real Time Kinematic Surveying ..................................... 4-13
Chapter 5
Receiver and File Maintenance ........................... 5-1
Downloading Files to a Computer ................................... 5-1
Downloading Files Using Topcon Link .................... 5-2
...Using Windows Explorer ................................ 5-2
...Using Topcon Link .......................................... 5-3
Downloading Files Using TRU ................................. 5-5
Deleting Files from the Receiver’s SDHC Card
Using PC-CDU ................................................................ 5-7
Deleting Files from the Receiver Using TRU ................. 5-9
Managing Receiver Memory ........................................... 5-10
Initializing the File System .............................................. 5-11
Initializing the File System Using TRU .................... 5-11
Managing Receiver Options ............................................ 5-11
Checking the Receiver’s OAF using TRU ................ 5-12
Checking the Receiver’s OAF using PC-CDU ......... 5-12
Loading an OAF using TRU ..................................... 5-14
Loading an OAF using PC-CDU .............................. 5-15
Clearing the NVRAM ...................................................... 5-17
Clearing the NVRAM Using the MINTER .............. 5-17
Clearing the NVRAM Using TRU ............................ 5-18
Clearing the NVRAM Using PC-CDU ..................... 5-18
Changing Receiver Modes ............................................... 5-19
Entering Extended Information Mode ...................... 5-19
Sleep (Off) Mode ...................................................... 5-20
Loading New Firmware Using TRU ............................... 5-21