Topcon Net-G3A User Manual

Introduction
NET-G3A Operator’s Manual
1-12
Table 1-1 describes the REC LED status when using the FN button.
Table 1-1. FN Button Operations and REC LED Status
FN Key REC LED Status
When data recording is off, and the FN key is...
Not pressed
No light No data recording.
Orange blink Internal file system test in progress.
Red No free memory; hardware problem with
data recording; no CF card.
Pressed for < 1
second
If FN key mode is “LED blink mode switch”
Orange Release to change information mode.
If FN key mode is “Occupation mode switch”
Orange No function.
Pressed for 1–5
seconds
If FN key mode is “LED blink mode switch”
Green Release to start data recording (post-
processing occupation mode undefined).
If FN key mode is “Occupation mode switch”
Green Release to start recording (Kinematic or
Static post-processing occupation mode).
Pressed for 5–8
seconds
Red Release to turn serial port A baud rate to
9600 bps.
Pressed for > 8
seconds
No light No function.
Net-G3A_OM_Book.book Page 12 Thursday, May 14, 2009 8:49 AM

Topcon Net-G3A Specifications

General

Brand	Topcon
Model	Net-G3A
Category	Receiver
Language	English