Toro Reelmaster 5100-D - Page 172

________________________________________________________________________________________
_____________________________________________ ________________ ______ ________________ ______ ________________ ___________________________________
_____________________________________________ ________________ ______ ________________ ______ ________________ ___________________________________
__
__ __ __ __ __ __
__ __ __ __ __ __
Condition Possible Cause Correction
Front cutting units do not operate Problem with solenoid S1. Test solenoid S1 and
replace if
in either direction (raise and faulty.
lower function OK).
Check wiring to S1 solenoid and
repair if faulty.
Problem with S7 solenoid. Check wiring to S7 solenoid and
repair if faulty.
Hydraulic problem. See Troubleshooting section of
Chapter 4 - Hydraulic System.
Rear cutting units do not operate Problem with solenoid S2. Test solenoid S2 and replace if
in either direction (raise and faulty.
lower function OK).
Check wiring to S2 solenoid and
repair if necessary.
Hydraulic problem. See Troubleshooting sect
ion of
Chapter 4 - Hydraulic System.
Cutting units operate, but speed Problem with solenoid VS1 or VS2 Test solenoid VS
1 (front cutting
is either too slow or too fast and (only front or rear cutting units will units) or VS2 (rear cutting units)
is not
regulated by changing the be affected). and replace if faulty.
HOC selector or tract
ion speed.
Check wiring to VS1 or VS2
solenoid and repair if faulty.
Problem with reel speed sensor Check affected reel
speed sensor
(only front or rear cutting units will (front or rear) and replace if faulty.
be affected).
Check wiring to affected reel
speed sensor and repair if faulty.
Problem with HOC selector. Check calibration of HOC
selector and replace if necessary.
Check wiring to HOC selector
and repair if necessary.
Problem with traction speed sensor. Check speedometer for proper
performance. If it is not
functioning, check operation of
traction speed sensor and
replace if faulty.
Check wiring to traction speed
sensor
and repair if necessary.
Troubleshooting Page 5 -
14 Reelmaster
®
5100-D