Toshiba E-STUDIO2008A - Page 151

4
© 2015 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO2008A/2508A/3008A/3508A/4508A/5008A
DISASSEMBLY AND REPLACEMENT
4 - 31
[B] Installing the carriage wire
(1) Install a new wire as shown on the right
when replacing the carriage wire.
[1] Wire pulley
[2] Carriage wire
[3] Carriage-2
[4] Idler pulley
[5] Hook
[6] Tension spring
[7] Front side
[8] Rear side
Notes:
It is not necessary to adjust the carriage wire
tension since a certain tension is applied to
the carriage wires through the tension
springs. Make sure the tension applied to the
wire is normal.
Fig. 4-81
Fig. 4-82
[3]
[4]
[6]
[1]
[5]
[2]
[7]
[3]
[4]
[6]
[1]
[5]
[2]
[8]