Toshiba E-STUDIO2008A - Page 152

e-STUDIO2008A/2508A/3008A/3508A/4508A/5008A © 2015 TOSHIBA TEC CORPORATION All rights reserved
DISASSEMBLY AND REPLACEMENT
4 - 32
[C] Winding on the wire pulley
(1) Insert the ø3 ball terminal [1] located at the
center of the wire into a hole on the wire
pulley. One end of the wire with the hook [2]
attached comes to the outside.
(2) Wind the wires around the wire pulleys of the
front side [3] and rear side [4]. The number of
turns to be wound are as follows: 3 [5]
toward the opposite side (outside) of the
pulley boss, and 3 [6] toward the pulley boss
side (inside).
[7] Black
[8] Silver
Notes:
When winding the wire onto the pulley, be
sure to note the following.
• Do not twist the wire.
• Wind the wires tightly so that they are in
complete contact with the surface of the
pulleys.
• Each turn should be pushed against the
previously wound turn so that there is no
space between them.
Fig. 4-83
Fig. 4-84
(3) After winding the wires around the pulleys,
attach the wire holder jigs to prevent the wire
from coming loose.
Notes:
1. When attaching the wire holder jig [9],
make sure that the wire has not shifted or
become loose.
2. The wire should come out of the slot of
the wire holder jig [9] and be passed
under the jig arm [10].
3. When installing the wire holder jig, be
careful of the orientation.
Fig. 4-85
[6] [5]
[1]
[7]
[3]
[2]
[6][5]
[1]
[8]
[2]
[4]
[10]
[9]
[9]