e-STUDIO2008A/2508A/3008A/3508A/4508A/5008A © 2015 TOSHIBA TEC CORPORATION All rights reserved
SETTING / ADJUSTMENT
6 - 84
<Recycled paper mode>
*Example
When A3 and plain paper with the recycled paper mode are set in [1-2] and [1-3], the number of
LED blinking times is 2.
(2) Press [Button1] for the number of LED blinking times you want to set.
Notes:
The larger the number you set is, the faster the paper exiting speed becomes.
The smaller the number you set is, the slower the paper exiting speed becomes.
After changing the setting, check the number of LED blinking times. Normally, the number of LED
blinking times is increased by 1 from the default. If paper trailing edge still remains, increase the
number by 2 from the default.
*Example of operation
To change the number of LED blinking times from 2 to 3, press [Button1] three times.
(3) Press [Button2] once.
(4) Press [Button1] and [Button2] simultaneously.
Plain paper Thick paper 1 Thick paper 2 Thick paper 3
Others 2 2 2 2
A3 2 2 2 2
A4 4 4 4 4
A4-R 3 3 3 3
A5 2 2 2 2
A5-R 4 4 4 4
A6-R 2 2 2 2
B4 3 3 3 3
B5 3 3 3 3
B5-R 2 2 2 2
FOLIO 2 2 2 2
LD 5 5 5 5
LG 9 9 9 9
LT 6 6 6 6
LT-R 3 3 3 3
ST 2 2 2 2
ST-R 3 3 3 3
COMP 2 2 2 2
13”LG 2 2 2 2
8.5”SG 2 2 2 2
8K 2 2 2 2
16K 2 2 2 2
16K-R 2 2 2 2
A3 wide 2 2 2 2
To Next Page
Loading...
