8
© 2015 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO2008A/2508A/3008A/3508A/4508A/5008A
ERROR CODE AND TROUBLESHOOTING
8 - 19
CB60 Finisher related
service call
Stapler shift motor abnormality: Stapler shift motor is not
rotating or staple unit is not moving normally.
[MJ-1101/1107/MJ-1106/1108]
P. 8-195
CB80 Backup RAM data abnormality:
Abnormality of checksum value on finisher controller PC
board is detected when the power is turned ON.
[MJ-1101/1107/MJ-1106/1108]
EEPROM data abnormality: An error occurs during the
writing of data into the EEPROM of the Finisher. [MJ-
1032/MJ-1033]
P. 8-196
P. 8-196
CB81 Flash ROM abnormality: Abnormality of checksum value
on finisher controller PC board is detected when the
power is turned ON. [MJ-1101/1107/MJ-1106/1108]
P. 8-197
CB82
Finisher - Main CPU program error P. 8-197
CB83
Saddle Stitch Finisher - Main CPU program error [MJ-
1106/1108]
P. 8-197
CB84
Hole Punch Unit - Main CPU program error P. 8-198
CB90
Paper pushing plate motor abnormality: Paper pushing
plate motor is not rotating or paper pushing plate is not
moving normally.
P. 8-198
CB91
Saddle Stitch Finisher flash ROM abnormality [MJ-1106/
1108]
P. 8-199
CB92
Saddle Stitch Finisher RAM abnormality [MJ-1106/1108] P. 8-199
CB93
Additional folding motor abnormality [MJ-1106/1108] P. 8-199
CB94
Saddle transport motor abnormality [MJ-1106/1108] P. 8-200
CB95
Stacker motor abnormality [MJ-1106/1108] P. 8-200
CBA0 Front saddle stapler home position error: The stapler
home position detection is abnormally operated and
finished. [MJ-1106/1108]
P. 8-200
CBB0 Rear saddle stapler home position error: The stapler
home position detection is abnormally operated and
finished. [MJ-1106/1108]
P. 8-201
CBC0 Saddle Stitch Finisher side alignment motor (M15)
abnormality: The alignment motor is not rotating or the
alignment plate is not working properly. [MJ-1106/1108]
P. 8-201
CBE0 Saddle Stitch Finisher folding motor (M17) abnormality:
The folding motor is not rotating or the folding roller is not
moving normally. [MJ-1106/1108]
P. 8-202
CBF0 Stacker motor (M9) abnormality:
The stacker motor is not rotating. [MJ-1033]
P. 8-202
Error code Classification Contents Troubleshooting
To Next Page
Loading...
