Toshiba E-STUDIO2008A - Page 646

e-STUDIO2008A/2508A/3008A/3508A/4508A/5008A © 2015 TOSHIBA TEC CORPORATION All rights reserved
ERROR CODE AND TROUBLESHOOTING
8 - 108
[E726] Transport/exit signal reception jam
[E731] Stop jam at the exit sensor
Classification Error content
RADF jam Transport/exit signal reception jam
Check item Measures
RADF board • Board check
• Connector check
• Harness check
SLG board • Board check
• Connector check
• Harness check
Switching power supply • Check if the 24V and 5V outputs of the switching power supply
are normal.
• Board check
• Connector check
• Harness check
Parts to be replaced Remark
RADF board
SLG board
Switching regulator
Classification Error content
RADF jam Stop jam at the exit sensor
Check item Measures
Exit roller Clean the registration roller if it is stained.
Exit sensor • Sensor check
(Perform the input check: 03-[FAX] ON[7]/[E])
• Connector check (CN74)
• Harness check
RADF board • Board check
• Connector check (CN74)
• Harness check
Parts to be replaced Remark
Exit sensor
RADF board
Exit roller Replace it if it is worn out.