e-STUDIO2008A/2508A/3008A/3508A/4508A/5008A © 2015 TOSHIBA TEC CORPORATION All rights reserved
ERROR CODE AND TROUBLESHOOTING
8 - 140
MJ-1106/1108
[ED14] Rear alignment plate home position error
MJ-1101/1107
MJ-1106/1108
Check item Measures
Front alignment plate Move the front alignment plate.
Fix any mechanical problem.
Front alignment plate home
position sensor
Check if there is a disconnection of the connector, incorrect
installation or breakage of the front alignment plate home position
sensor (S7). If there is, reinstall the sensor correctly or replace it.
Check if the connector (CN18) on the finisher controller PC board is
disconnected from the front alignment plate home position sensor
(S7) and the harnesses are open circuited. Correct if so.
Front alignment motor Check if the connector (CN17) on the finisher controller PC board is
disconnected from the front alignment motor (M5) and the
harnesses are open circuited. Correct if so.
Parts to be replaced Remark
Front alignment plate home
position sensor
Finisher controller PC board
Classification Error content
Finisher jam
Rear alignment plate home position error
Check item Measures
Rear alignment plate Move the Rear alignment plate. If there is any mechanical problem,
fix its mechanism.
Rear alignment motor
Rear alignment plate home
position sensor
Finisher controller PC board
Check if the connectors on the finisher controller PC board are
disconnected from the Rear alignment plate home position sensor
(S8) and the Rear alignment motor (M10), or the harnesses are
open circuited. Correct if any.
Parts to be replaced Remark
Front alignment motor
Front alignment plate home
position sensor
Finisher controller PC board
Check item Measures
Rear alignment plate Move the rear alignment plate.
Fix any mechanical problem.
Rear alignment plate home
position sensor
Check if there is a disconnection of the connector, incorrect
installation or breakage of the rear alignment plate home position
sensor (S8). If there is, reinstall the sensor correctly or replace it.
Check if the connector (CN18) on the finisher controller PC board is
disconnected from the rear alignment plate home position sensor
(S8) and the harnesses are open circuited. Correct if so.
To Next Page
Loading...
