8
© 2015 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO2008A/2508A/3008A/3508A/4508A/5008A
ERROR CODE AND TROUBLESHOOTING
8 - 141
[ED15] Paddle home position error
MJ-1101/1107
MJ-1106/1108
Rear alignment motor Check if the connector (CN17) on the finisher controller PC board is
disconnected from the rear alignment motor (M6) and the
harnesses are open circuited. Correct if so.
Parts to be replaced Remark
Rear alignment plate home
position sensor
Finisher controller PC board
Classification Error content
Finisher jam
Paddle home position error
Check item Measures
Paddle Rotate the paddle. If there is any mechanical problem, fix its
mechanism.
Paddle home position sensor
Paddle motor
Finisher controller PC
board
Check if the connectors on the finisher controller PC board are
disconnected from the paddle home position sensor (S3) and the
paddle motor (M8), or the harnesses are open circuited. Correct if
any.
Parts to be replaced Remark
Paddle motor
Paddle home position sensor
Finisher controller PC board
Check item Measures
Rear alignment plate Move the rear alignment plate.
Fix any mechanical problem.
Rear alignment motor Check if the connector (CN17) on the finisher controller PC board is
disconnected from the rear alignment motor (M6) and the
harnesses are open circuited. Correct if so.
Parts to be replaced Remark
Rear alignment motor
Finisher controller PC board
Check item Measures
To Next Page
Loading...
