3 Tests and Diagnostics 3.21 ONLY ONE TEST
Subtest 09 Acceleration sensor
This subtest detects and corrects the each axis (X, Y, Z).
NOTE: Make sure that this subtest is executed on the following condition:
1. Flat desk with vertical plane to get the stability of machine.
2. Prevent the machine from shake or shock.
Set the machine
against the vertical plane
with the Front upward
<Example>
Vertical plane
Flat desk
The figure below shows the name and position of each side.
Top
(heaven surface)
Back Right side
(right)
FrontLeft side
(left)
QOSMIO G20 Maintenance Manual (960-511) [CONFIDENTIAL] 3-55
To Next Page
Loading...
Need help?
General