4 Replacement Procedures 4.36 Display latch hook
4.36 Display latch hook
Removing the display latch hook
The following describes the procedure for removing the display latch hook (See Figure 4-55).
1. Remove the following screws securing the display latch hook.
M2.5x6.0C PSP TIGHT screw x2
2. Pull up and remove the display latch hook from the display rear cover.
M2.5x6.0C PSP TIGHT
Display latch hook
Figure 4-55 Removing the display latch hook
Installing the display latch hook
The following describes the procedure for installing the display latch hook (See Figure 4-55).
1. Install the display latch hook to the display rear cover and secure it with the
following screws.
M2.5x6.0C PSP TIGHT screw x2
QOSMIO G20 Maintenance Manual (960-511) [CONFIDENTIAL] 4-85
To Next Page
Loading...
