4.15 Sound board 4 Replacement Procedures
4.15 Sound board
Removing the sound board
The following describes the procedure for removing the sound board (See Figure 4-25).
1. Disconnect the Sound harness from the connector CN9510 on the SD board.
2. Disconnect the Power SW harness from the connector CN9521 on the SD board.
3. Turning up the insulator, remove the following screws securing the SD board and
remove the SD board from the cover assembly.
M2.5x3.0S FLAT BIND screw x3
Power SW harness
Sound harness
M2.5x3.0S FLAT BIND
CN9510
Sound board
CN9521
M2.5x3.0S FLAT BIND
Figure 4-25 Removing the sound board
4-42 [CONFIDENTIAL] QOSMIO G20 Maintenance Manual (960-511)
To Next Page
Loading...
