4.28 Bluetooth module 4 Replacement Procedures
Installing the bluetooth module
The following describes the procedure for installing the bluetooth module (See Figure 4-41).
1. Install the bluetooth module and secure it with the following screw.
M2.0x3.0C S-THIN FLAT BIND screw x1
2. Connect the bluetooth flat cable to the connector on the bluetooth module.
3. Connect the bluetooth antenna cable from the connector on the bluetooth module.
4. Cover the bluetooth module slot with the insulator.
4-66 [CONFIDENTIAL] QOSMIO G20 Maintenance Manual (960-511)
To Next Page
Loading...
