4 Replacement Procedures 4.10 Speaker (L) & Modem jack
Installing the speaker (L) & Modem jack
The following describes the procedure for installing speaker (L) & modem jack (See Figure
4-16).
1. Install the modem jack to the bottom cover assembly.
2. Wind the speaker (L) cable to the guide of bottom cove assembly and install the
speaker (L) in the slot.
3. Connect the AV-IN harness to the connector CN9614 on the AV-IN board and
arrange the harness along the guides.
QOSMIO G20 Maintenance Manual (960-511) [CONFIDENTIAL] 4-31
To Next Page
Loading...
