4.13 Optical disk drive 4 Replacement Procedures
Assembling the ODD assembly
The following describes the procedure for assembling the ODD assembly from the optical
disk drive (See Figure 4-22).
1. Install the ODD cover to the ODD base assembly by sliding the hook into the slot of
ODD base assembly.
2. Secure the ODD cover with the following screws.
M1.8x2.0C S-THIN FLAT BIND screw x4
4-38 [CONFIDENTIAL] QOSMIO G20 Maintenance Manual (960-511)
To Next Page
Loading...
