Toshiba Qosmio G20 - Page 418

J.2Analysis and handling by Drive Log Appendix J Maintenance of TOSHIBA RAID
J.2 Analysis and handling by Drive Log
Follow the below procedures to analyze.
En
d
Replace the second HDD
with new (good) one.
No
Port 1
(2) If necessary, analyze the
Drive Log and identify
the cause of failure.
(1) Which port of
HDD failed?
Port 0
(4) Change the status of the
failed HDD to “OFFLINE”.
Replace the second HDD
with new (good) one.
Replace the built-in HDD with
the second HDD removed.
(3) Does operation
miss cause i
t
?
Yes
(2) If necessary, analyze the
Drive Log and identify
the cause of failure.
Boot the independent utility
and check the Physical Drive
status.
Figure J-2 Flowchart of Analysis and handling by Drive Log
J-2 [CONFIDENTIAL] QOSMIO G20 Maintenance Manual (960-511)