4.14 Touch pad 4 Replacement Procedures
TECRA A9/TECRA S5/TECRA P5/Satellite Pro S200 Maintenance Manual (960-633) [CONFIDENTIAL] 4-41
Installing the Touch pad
To install the touch pad, follow the steps below and refer to Figure 4-23 and 4-24.
1. Connect the touch pad cable to the connector on the touch pad and stick the glass
tape in place.
2. Turn over the touch pad assembly and seat it to the slot.
3. Secure the touch pad assembly with the following screw.
• M2.5×10B FLAT HEAD screw ×1
4. Install the touch pad cover while engaging latches.
To Next Page
Loading...
