4.12 Optical drive 4 Replacement Procedures
4.12 Optical drive
Removing the Optical drive
To remove the optical drive, follow the steps below and refer to Figure 4-19 and 4-20.
CAUTION: After removing the optical drive, do not put fingers inside the slot. It may
cause injury.
1. Close the display and turn over the computer.
2. Remove the following screw securing the optical drive.
• M2.5×6B FLAT HEAD screw ×1
3. Turn over the computer and open the display.
4. Remove the optical drive from the connector on the system board while pushing it in
the direction in the figure below.
Optical drive
(Push it on the front of
the cover assembly)
Optical drive
(In the slot)
M2.5×6B FLAT HEAD
Figure 4-19 Removing the optical drive
TECRA A9/TECRA S5/TECRA P5/Satellite Pro S200 Maintenance Manual (960-633) [CONFIDENTIAL] 4-33
To Next Page
Loading...
