Toshiba Tecra M10 - Page 295

4.21 GFX board/GFX fin 4 Replacement Procedures
2. Remove the following screws and separate the GFX fin and GFX board.
• M2.0×3C S-THIN HEAD screw ×4
GFX board
GFX fin
M2.0x3C S-THIN HEAD
M2.0x3C S-THIN HEAD
Cool sheet
Figure 4-39 Removing the GFX board/GFX fin (2)
TECRA M10 Maintenance Manual (960-685) [CONFIDENTIAL] 4-63