2.4 System Board Troubleshooting 2 Troubleshooting Procedures
TECRA M10 Maintenance Manual (960-685) [CONFIDENTIAL] 2-31
NOTE: Status outputted by the test means the last error detected in the debug port test.
Check 1 If the D port is status F11Eh or F120h is displayed, go to “HDD Trouble shooting
Procedure in Section 2.6.
Check 2 If any other D port status error code is displayed, perform Procedure 3.
D port error code is as follows:
Error code Contents
F003h or F004h SC initialization error
F00Bh BIOS update error
F117h Exception check error
F121h Clock generator error
To Next Page
Loading...
