TP-Link T2500G-10TS - Page 14

4
Chapter
Introduction
Chapter 6 VLAN This module is used to configure VLANs to control broadcast in
LANs. Here mainly introduces:
 802.1Q VLAN: Configure port-based VLAN.
 MAC VLAN: Configure MAC-based VLAN without changing
the 802.1Q VLAN configuration.
 Protocol VLAN: Create VLANs in application layer to make
some special data transmitted in the specified VLAN.

VLAN VPN: VLAN VPN allows the packets with VLAN tags of
private networks to be encapsulated with VLAN tags of
public networks at the network access terminal of the
Internet Service Provider.
 GVRP: GVRP allows th
e switch to automatically add or
remove the VLANs via the dynamic VLAN registration
information and propagate the local VLAN registration
information to other switches, without having to individually
configure each VLAN.
Chapter 7 Spanning Tree This module is used to configure spanning tree function of the
switch. Here mainly introduces:

STP Config: Configure and view the global settings of
spanning tree function.
 Port Config: Configure CIST parameters of ports.
 MSTP Instance: Configure MSTP instances.
 STP
Security: Configure protection function to prevent
devices from any malicious attack against STP features.
Chapter 8 DHCP This module is used to configure DHCP function of the switch.
The switch can work as DHCP relay, and here mainly introduces
DHCP relay function.

DHCP Relay: Configure the DHCP relay feature.
Chapter 9 Multicast
This module is used to configure multicast function of the
switch. Here mainly introduces:

IGMP Snooping: Configure global parameters of IGMP
Snooping function, port properties
, VLAN and multicast
VLAN.

MLD Snooping: Configure global parameters of MLD
Snooping function, port properties, VLAN and multicast
VLAN.
 Multicast Table:
View the information of IPv4 and IPv6
multicast groups already on the switch.