TP-Link T2500G-10TS - Page 15

5
Chapter
Introduction
Chapter 10 QoS This mo
dule is used to configure QoS function to provide
different quality of service for various network applications and
requirements. Here mainly introduces:
 DiffServ: Configure priorities, port priority, 802.1P priority and
DSCP priority.
 Bandwidth Control: Configure rate limit feature to control the
traffic rate on each port; configure storm control feature to
filter broadcast, multicast and UL frame in the network.
 Voice VLAN: Configure voice VLAN to transmit voice data
stream within the specified VLAN so as
to ensure the
transmission priority of voice data stream and voice quality.
Chapter 11 ACL
This module is used to configure match rules and process
policies of packets to filter packets in order to control the
access of the illegal users to the network.
Here mainly
introduces:
 Time-Range: Configure the effective time for ACL rules.
 ACL Config: ACL rules.
 Policy Config: Configure operation policies.

Policy Binding: Bind the policy to a port/VLAN to take its
effect on a specific port/VLAN.
Chapter 12 Network Security
This module is used to configure the multiple protection
measures for the network security. Here mainly introduces:
 IP-MAC Binding: Bind the IP address, MAC address, VLAN ID
and the connected Port number of the Host together.
 ARP Inspection: Configure ARP inspection feature to prevent
the network from ARP attacks.
 DoS Defend: Configure DoS defend feature to prevent DoS
attack.

802.1X: Configure common access control mechanism for
LAN ports to solve mainly authentication and security
problems.
 AAA:
Configure the AAA function protect the device from
unauthorized operations.
 PPPoE Config: Configure the PPPoE Circuit-
ID Insertion
function to support the authentication, authorization, and
accounting (AAA) access requests on an Ethernet interface.
Chapter 13 SNMP This module is used to configure SNMP function to provide a
management frame to monitor and maintain the network
devices. Here mainly introduces:
 SNMP Config: Configure global settings of SNMP function.
 Notification: Configure notification fun
ction for the
management station to monitor and process the events.
 RMON: Configure RMON function to monitor network more
efficiently.