271
Figure 16-2 Open Hyper Terminal
3. Download Firmware via bootUtil menu
To download firmware to the switch via FTP function, you need to enter into the bootUtil menu
of the switch and take the following steps.
1） Connect the console port of the PC to the console port of the switch and open hyper
terminal. Connect FTP server to port 1 of the switch.
2） Power off and restart the switch. When you are prompted that “Press CTRL-B to enter
the bootUtil” in the hyper terminal, please press CTRL-B key to enter into bootUtil
menu shown as Figure 16-3.
Figure 16-3 bootUtil Menu
As the prompt is displayed for a short time, you are suggested not to release the CTRL-B
key until you enter into bootUtil menu after powering on the switch.
To Next Page
Loading...
