transnorm TS 4800 - Page 76

Maintenance and repair
Loosening/tensioning/adjusting the drive belt
76
Operating instructions: Outfeed conveyor TS 4800
Version 3.6ENG, 27.01.2020
4. Check that the belt runs correctly.
5. Switch off the machine.
6. Repeat steps 2 to 5 until the belt shows a correct running cycle.
7. On design versions with tensioning bolts: Tighten the counternuts (1).
 Drive belt is tensioned/adjusted.
 Assemble the covers
Complete the following steps:
 Assembly is carried out in the reverse order.
 Covers are assembled.

Drive belt is tensioned/adjusted.