4. At the bottom of the left hand panel, click Save.
5. Select the Config you would like to save the settings to, then click Save Settings to
Flash,.
Note: This step saves all configuration changes to the NV-RAM to ensure that if the
switch is rebooted or power cycled, the configuration changes will still be applied.
Access Profile List
Security > ACL > Access Profile List
The Access Profile List allows users to view the active ACL profiles.
1. Log into your switch management page (see “Access your switch management page”
on page 5).
2. Click on Security, click ACL, and click on Access Profile List.
In the list, you can click Show Details to view the ACL Profile details, click Edit/New
Rules to edit or create rule details, or delete the entry. You can also click Delete All to
delete all of the entries in the table.
4. At the bottom of the left hand panel, click Save.
5. Select the Config you would like to save the settings to, then click Save Settings to
Flash.
Note: This step saves all configuration changes to the NV-RAM to ensure that if the
switch is rebooted or power cycled, the configuration changes will still be applied.
To Next Page
Loading...
