o IP Address: Enter the new switch IP address you would like to
statically assign. (e.g. 192.168.200.200)
o Subnet Mask: Enter the new switch subnet mask. (e.g. 255.255.255.0)
6. At the bottom of the left hand panel, click Save.
7. Select the Config you would like to save the settings to, then click Save Settings to
Flash.
Note: This step saves all configuration changes to the NV-RAM to ensure that if the
switch is rebooted or power cycled, the configuration changes will still be applied.
IPv4 ARP Aging Time
System > L3 Feature > IPv4 ARP Aging Time
This section allows you to set the timeout for the switch’s ARP Table per each
configured VLAN.
1. Log into your switch management page (see “Access your switch management page”
on page 5).
2. Click on System, L3 Feature, and then IPv4 ARP Aging Time.
3. Click on Edit to change the value, then click Apply.
4. At the bottom of the left hand panel, click Save.
5. Select the Config you would like to save the settings to, click Save Settings to Flash,
then click OK.
Note: This step saves all configuration changes to the NV-RAM to ensure that if the
switch is rebooted or power cycled, the configuration changes will still be applied.
To Next Page
Loading...
