Click Continue, Proceed to this website, and accept the certificate if prompted.
4. At the bottom of the left hand panel, click Save.
5. Select the Config you would like to save the settings to, click Save Settings to Flash,
then click OK.
Note: This step saves all configuration changes to the NV-RAM to ensure that if the
switch is rebooted or power cycled, the configuration changes will still be applied.
SSH
Enable SSH (Secure Shell) management access
System > SSH
1. Log into your switch management page (see “Access your switch management page”
on page 5).
2. Click on System, and click on SSH.
3. Review the settings. Click Apply to save changes.
• SSH Status:
o Enabled – Enables SSH management access.
o Disabled – Disabled SSH management access.
• Port: Set the port number to use for SSH management access
4. At the bottom of the left hand panel, click Save.
To Next Page
Loading...
